Container Kit

Included in Kit:

• 1 Roll 1/2" x 100 ft. Poly Tubing Main Line (water source) (Now available in White or Black)
• 1 Snap-On Tap Adapter and Filter Assembly (No Pressure Regulator needed for this system)
• 15 Pressure Compensating Weighted Basket Assemblies (10 @ 18" and 5 @ 36" Long) These are assembled drippers. 18" and 36" describes the length of the micro tubing. The weight is on one end and goes into the pot The other end has an emitter which punches into the main line. If you would like these UNassembled....just let us know!
• 15 CLJ-3 White J-Clamps (hold 1/2" tubing in place on porch or columns, etc To use on brick walls, simply switch out plain screws for masonry ones. )
• 10 Insert Elbows 1/2" (Just in Case to make turns)
• 3 Insert Tees 1/2" (Just in Case to make turns in 2 directions)
• 1 Insert Coupling 1/2"
• 30 Ratchet Clamps (for insert fittings and Snap-On Tap Adapter/Filter Assembly. They hold the tubing on the fittings.)
• 1 Card of Goof Plugs (for oops made by punch)
• 2 Joiners for Micro Tubing (For Hang Basket Assemblies - just in case)
• 1 Key Punch
• 4 1/2" Figure-8 Ends (Closes off the 1/2" Poly Mainline)
• Instructions (SEE BELOW)

Note: * The Weights hold micro tubing in place in the basket OR POT and the plants just grow around it. You may easily cut the 18" and 36" assemblies if necessary. * No Pressure Regulator is needed due to the Pressure Compensating Emitters.